3Dmax" to create a metal hose for bathing

This tutorial teaches 3DMAX friends to create metal hoses for bathing. The tutorial mainly introduces the modeling process of metal hoses. The author has a unique idea and forwarded it to learn with friends from 3DMAX. First look at the renderings:

 

The specific modeling steps are as follows:

Choose to construct spline, spiral, and adjust the parameters as shown in the figure.

 

Add a squeeze command, squeeze out to the required level.

At this time, the normal line behind the extrusion is reversed. Add a normal line command to flip the normal line.

After adding an edit polygon command, enter the edge level.

Choose one side of the top and bottom at will.

Click the loop command to get all the upper and lower edges .

Select the extrude command, apply after extruding inward

In the second extrusion as shown in the figure, the purpose of this step is for the next welding, and the point is determined to be completed.

Parameters are welded to fit.

Finally remove the used edges.

Finally, I found that there are edges and corners in the extruded area on the inside, and add a smoothing command to automatically smooth it .

 


The material of this article comes from the Internet, collected and published by the 3DMAX model, and the copyright belongs to the original author. If there is any infringement, please contact the editor to correct it in time. [ Poke me into the learning circle ]

Guess you like

Origin blog.csdn.net/weixin_44386969/article/details/109023190