Right-click on the item bar and select split vertical to split the schematic and PCB files into the page display
. The corresponding selection of the schematic and PCB
should be under the schematic selection, tools–cross select mode corresponds to
the cross option. When there is a cross option, the selected state of the item can be set by yourself
Select in the schematic, cross display on the PCB, select tools----comp0nent placement ----rectangle arrage, and place the selected originals in a rectangle on the PCB.
If it is unsuccessful, it may be that the device is locked and you can unlock it.
A shortcut Align
design-rules to the left and right to set the PCB rules
Modify the spacing and line width
design —rules wizard
The minimum distance
T—D sets the rule check.
Right-click — online DRC ALL Offq cancels a series of rule checks, batch drc all off
only keeps the rule check of electrical connections
Shortcut key D—R rule design
Modify the label size, select one of the labels and then right-click to find similar objects, select all labels and then modify.
Place the original label in the middle of the original
crtl+a and select all the originals-press A in the blank area-press P.
