1. Create a virtual machine
1.0 to create a new virtual machine
1.0.1 Select Custom Configuration
Open VMware, click Create a new virtual machine.
As shown below:
1.0.2 Select a virtual machine hardware compatibility
As shown below:
1.0.3 install a guest operating system
Here, we have chosen to install the operating system later
As shown below:
1.0.4 Select a guest operating system
Here, we choose linux system, version centos64 bit
As shown below:
1.0.5 virtual machine named
Named as much as possible to regulate the professional
As shown below:
1.0.6 processor configuration
Default can
As shown below:
1.0.7 Memory Configuration
Here, we can choose 2G memory, 1G can be changed in the system to be installed when complete. I chose 1G memory.
As shown below:
1.0.8 Select the type of network
To facilitate learning, we chose to use Network Address Translation
As shown below;
1.0.9 Select I / O control type
Default can
As shown below:
1.0.10 select the disk types
Default can
As shown below:
Select Disk 1.0.11
Select Create a new virtual disk
As shown below:
1.0.12 Specify the disk capacity
Select the virtual disk is stored as a single file
As shown below:
1.0.13 specified disk file
Default can
As shown below:
1.0.14 Mount Centos Mirror
As shown below:
2.0 Installation Centos7 system
2.0.1 graphical installation
The following boot into the interface when the ↑ key to select install Centos, and then press the tab key
Input net.ifnames = 0 biosdevname = 0 After setting inspection, and press Enter to continue the installation system.
As shown below:
2.0.2 Select the installation language
Here, it is strongly recommended to choose English
As shown below:
2.0.3 configure the network, set the IP and hostname
Click NETWORK HOSTNAME.
As shown below:
2.0.4 Custom Partitioning
Click INSTALLATION DESTINATION
As shown below:
Create a / boot partition
/ Boot partition boot Boot system starts ships 200M
swap partition
swap swap partition when the system memory, act as a temporary memory. Usually a G
/ (Root partition)
Windows equivalent to the position of the C drive, software, files are stored. How much to surplus
Creating a Partition complete
2.0.5 Creating time zone
2.0.6 minimize installation system
2.0.7 set the root password to begin the installation
Here, we completed the installation of the entire Centos7 virtual machine. Here we VMware network configuration.
3.0 arrangement VMware Workstation
3.0.1 编辑→虚拟网络编辑器
4.0 通过Xshell连接系统
4.0.1 新建会话
到这里，我们就全部完成了。
作者：星辰追路人
本文版权归作者所有，欢迎转载，但未经作者同意必须保留此段声明，且在文章页面明显位置给出原文连接，否则保留追究法律责任的权利。