NOTE: make sure the operation before the power supply is connected and the device is not in an error state.
1, using the RS / 232 (9-pin) serial cable connected to the laptop serial switch.
Enter the following parameters:
-
Bits per second (bits per second): 9600
-
Data Bits (bits): 8
-
Parity (Parity): None
-
Stop Bits (stop bit): 1
-
Flow Control (Flow Control): None
Note: If a Unix system, then enter the following command set connection parameters: tip / dev / ttyb -9600
2 Click OK.
3. ENTER to 3 times at the terminal prompt.
4. Enter the admin administrator password. The default password is password.
5. Enter the following command: iipaddrset
It will appear the following prompt:
Note: Figures in brackets is the current setting. ENTER to set the current value may be maintained.
Ethernet IP Address [10.77.77.77]: <Enter the new IP address>
Ethernet Subnetmask [255.0.0.0]: <enter a new subnet mask. Press Enter to keep the default settings>
Fibre Channel IP Address [0.0.0.0]: <enter the new FC IP address. Press Enter to keep the default settings>
Fibre Channel Subnetmask [0.0.0.0]: <Enter the new FC IP subnet mask. Press Enter to keep the default settings>
Gateway Address [0.0.0.0]: <enter a new gateway address. Press Enter to keep the default settings>
Set IP Address now? [y = set now, n = next reboot]: <输入y>
6 Confirm the new IP address is set up correctly by ping / or ipaddrshow command.
7. After confirmation, you can try to use the cable network port connected to the switch, access by the web browser management interface