Compass GPS network clock source domain controller, including setting method
Anhui Beijing-Technology to provide information
The domain controller can not connect to external networks, sometimes the time delay, the core routers are time synchronized network time server, the domain controller time synchronous core routing
Prerequisite: Enable the NTP service routing, core routing can synchronize the time outside the network.
Reference - may also set up their own HR-901GB a network time server, such as the following:
a network domain controller time source is provided, including methods
Method / Step
1
in the primary domain controller registry settings as follows
HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\services\W32Time\Parameters
“Type”=“NTP”
“NtpServer”=“X.X.X.X,0x9”
Where XXXX is the IP address of the router
2
test synchronization time
Run -CMD
—W32TM /resync
operation result:
Resync command is sent to the local computer
Successfully carried out their orders.
After the command prompt if the above instructions that appear successful
You can also look at the system log:
The time provider NtpClient is from 192.168.0.1,0x9: receiving valid time data (ntp.m | 0.0.0.0 | 0x9 123-> 192.168.0.1:123).
System Time from 2014 - 07T10 - 10: Change 23.921217900Z to 2014 - 10 - 07T10:: 04 06: 33.232421000Z.
Now serving time with time sources 192.168.0.1,0x9 (ntp.m | 0x9 | 0.0.0.0: 123-> 192.168.0.1:123) time synchronization system.
System Time from 2014 - 07T10 - 10: Change 33.232421000Z to 2014 - 10 - 07T10:: 06 06: 33.232000000Z.
END
Notes
of course, need to set the time of the service router omitted here
if NTP time server can be independently set manufacturers to provide support
