第一步:让arduinoIDE支持wemos D1MiNi
选择“文件/首选项”
第二步:将开发板添加到IDE里
将http://arduino.esp8266.com/stable/package_esp8266com_index.json这个json地址键入下图所示红框的位置,点击“好”。
补充:点击右侧这个按钮可以让你同时键入多个开发板的json。用行隔开就行 不需要单独加符号
第三步:添加开发板
选择“工具/开发板/开发板管理”
第四部:
在打开的开发板管理器界面 搜索“esp”,安装下图红框这个,版本号可能因为你跟我安装的时间不同而有所不同。不重要、
第五步:
选择好开发板 参数如图所示设置就好
第六步:打开自带的demo
第七步 在D1和G上连接一个led串一个220欧电阻
第八步 编译上传 就可以看到灯闪烁了
/*
ESP8266 Blink by Simon Peter
Blink the blue LED on the ESP-01 module
This example code is in the public domain
The blue LED on the ESP-01 module is connected to GPIO1
(which is also the TXD pin; so we cannot use Serial.print() at the same time)
Note that this sketch uses LED_BUILTIN to find the pin with the internal LED
*/
void setup() {
pinMode(D4, OUTPUT); // D4引脚设置成输出
}
void loop() {
//D4上的led亮5s灭1s 板载led亮1s灭5s
digitalWrite(D4, HIGH); // 将D4引脚设为高电平(板载灯连接的这个引脚但是反向 所以板载灯闪烁和外界LED相反
delay(5000); // 延时5秒
digitalWrite(D4, LOW); // 将D4引脚设为低电平
delay(1000); // 延时1s
}