1、下载
下载地址：http://www.apache.org/dyn/closer.cgi/zookeeper/ ，下载解压到D:\tools 如下图所示：
2、启动
进入bin文件夹下，如下图：
3、运行(windows环境)
双击zkServer.cmd，发现闪退
4、问题解决
打开zkServer.cmd进行编辑，在尾部加pause,如下图：
保存，再次双击，发现找不到zoo.cfg文件，如下图：
进入conf文件夹下，将zoo_sample.cfg文件复制一份修改为zoo.cfg,如下图：
修改zoo.cfg
|
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
|
# The number of milliseconds of each tick
tickTime=
2000
# The number of ticks that the initial
# synchronization phase can take
initLimit=
10
# The number of ticks that can pass between
# sending a request and getting an acknowledgement
syncLimit=
5
# the directory where the snapshot is stored.
#
do
not use /tmp
for
storage, /tmp here is just
# example sakes.
dataDir=D:/tools/zookeeper-
3.4
.
9
/data
# the port at which the clients will connect
clientPort=
2181
# the maximum number of client connections.
# increase
this
if
you need to handle more clients
#maxClientCnxns=
60
#
# Be sure to read the maintenance section of the
# administrator guide before turning on autopurge.
#
# http:
//zookeeper.apache.org/doc/current/zookeeperAdmin.html#sc_maintenance
#
# The number of snapshots to retain in dataDir
#autopurge.snapRetainCount=
3
# Purge task interval in hours
# Set to
"0"
to disable auto purge feature
#autopurge.purgeInterval=
1
|
至此ZooKeeper在Windows操作系统中安装配置完毕，但需要指出的是ZooKeeper是使用java编写的，因此运行ZooKeeper之前必须安装Java环境——配置JDK，且JDK的版本要大于或等于1.6。
5、再次启动
双击zkServer.cmd,出现如下界面，则启动成功
