用米思齐（mixly）或者Arduino制作红外线遥控灯

----用米思齐（mixly）或者Arduino制作红外线遥控灯

一、先设置红外线遥控和LED灯的端口

二、在面包板上把LED灯的电路接好，注意要接电阻！

三、Arduino代码

#include <IRremote.h>

long ir_item;

IRrecv irrecv_5(5);
decode_results results_5;

void setup(){
  Serial.begin(9600);
  irrecv_5.enableIRIn();
}

void loop(){
  if (irrecv_5.decode(&results_5)) {
    ir_item=results_5.value;
    String type="UNKNOWN";
    String typelist[14]={"UNKNOWN", "NEC", "SONY", "RC5", "RC6", "DISH", "SHARP", "PANASONIC", "JVC", "SANYO", "MITSUBISHI", "SAMSUNG", "LG", "WHYNTER"};
    if(results_5.decode_type>=1&&results_5.decode_type<=13){
      type=typelist[results_5.decode_type];
    }
    Serial.print("IR TYPE:"+type+"  ");
    Serial.println(ir_item,HEX);
    if (ir_item == 0xFFA25D) {
      pinMode(A3, OUTPUT);
      digitalWrite(A3,HIGH);

    }
    if (ir_item == 0xFF629D) {
      pinMode(A4, OUTPUT);
      digitalWrite(A4,HIGH);

    }
    if (ir_item == 0xFFE21D) {
      pinMode(A5, OUTPUT);
      digitalWrite(A5,HIGH);

    }
    delay(1000);
    irrecv_5.resume();
  } else {
    pinMode(A3, OUTPUT);
    digitalWrite(A3,LOW);
    pinMode(A4, OUTPUT);
    digitalWrite(A4,LOW);
    pinMode(A5, OUTPUT);
    digitalWrite(A5,LOW);
    delay(1000);
  }

}

四、图形化编程，米思齐模块

五、运行

六、我只是为了分享我的红外控制基础，大家可以根据自己的想法改一下我的程序。