When the bridges can be done at the relay with a home or corporate wireless network, there may be some places not covered by the signal, WIFI signal amplifier may be selected at this time (after insertion set only to power), a wireless router or idle.
Recently wireless signal boss office is not good, so I want to improve network status in two ways: 1 Adjust the original location of the wireless router (formerly the horn Gala Li to penetrate a solid 3 to 5 pillars and glass door) to open and a little higher position. 2 with a wireless router as a repeater bridge amplification (wireless router just to find a TPLINK AC1570 C7 from the Treasury, but the adapter is not too hard to force a match, and the top is in English and Korean, and domestic interface after login on the router not the same, such as in the management of the program no gadgets wireless bridge, there is no manual, tplink customer service could not get through or are not familiar with, toss a half to find the right trade Chinese technical support customer service, here to explain under TPLINK customer service system , online text services; hotline (Shenzhen Center 075,526,504,400 at plus 86 foreign countries, and the change from 1 to 5 say Chinese let them give you looking for Chinese technology, 0 household, industrial (domestic, foreign trade).) substantially bridging. steps
- By + WIFI wireless password ( the default is 8 bits PIN of the LAN interface), or via a wired router PC and
- The address of the router (192.168.0.1 or 192.168.1.1 or other already set the IP address) login, enter the administrator account and password (the default is adimin, if you forget to press the reset button more than 5s to reset the router (see router front row after all lit lamp off) and then reset the router administrator password)
- Set LAN, IP address and set the primary route segment but a number of unique new IP address (I set the 192.168.5.180), and then save, the router will restart inside the network.
- With new IP192.168.5.180 new login and password new router in System Tools - 2.4G choose which system parameters which enable WDS function; then click to select the SSID of scanning WIFI bridge of the main relay router SSID, and enter the password saved.
- Then turn off wireless parameter setting inside the DHCP function, then the status force to see whether the WDS function "RUN"
- Restart the router, the router connected to the same name as the primary SSID may be used.
You can refer to the following , but it is a domestic TPLINK, application management which has wireless bridges, without the gadgets you need to operate according to the above, and also to see official documents