Huawei simulator eNSP basic commands

Huawei simulator eNSP commonly used commands

This switched: https://blog.csdn.net/Key_book/article/details/80542264

Common Command Router Command line:
1. System View-
system view, we open the default command line prompt is a front angle brackets <>, which is a user view, when the input sys we can enter the system to view the operation of the routing

2.interface + interface name
is used to set the interface, for example, FE interfaces and router interfaces GE, we can enter the interface g 0/0/0 to select the specified set GE interface

3.ip address IP address of the subnet mask
is used to add an IP address, for example, I gave vlanif1 add an IP gateway can be used as a command ip address 192.168.1.1 24, before setting course we need to interface Vlanif 1 to enter the port

4.undo + command when the original configuration
can be canceled configuration information

5.rip
into the rip configuration, rip into rip1 protocol version and RIP2, rip1 in broadcast, multicast RIP2, routing protocol based on distance vector algorithm, number of hops as a measurement standard.

6.ctrl + z fast exit to user mode

7.quit exit the current settings

8.save save the configuration information

9.display ip routing-table routing table

Command +? View Help command