Network configuration includes AP / AC / Switch (1) Switch Configuration
When the AP POE power needed, the configuration in the step of exchanging the LAN port (provided the power switch supports POE)
1. Install HyperTerminal client (link attached below)
https://pan.baidu.com/s/1z1B3sVFKCnmHLi9Eqv08s
Extraction code: na17
2. Download the client after extracting run the .exe file inside end
After the Super Terminal area code and names can easily fill
In the establishment of the project will select the COM port, COM port to confirm the switch will pop up next property COM interface, just click the Restore Defaults Properties on the line
3. Go to the hyper terminal after the start of the write command
LAN switch port such as configuration POE power supply, then the following command:
<H3C>sys
[H3C]interface g1/0/1
[H3C-interface gigabitethern et1/0/1]poe enable
[H3C-interface gigabitethern et1/0/1]quit
[H3C]save
Note: Each write a carriage return line
After writing SAVE Enter appears asking you [Y / N] :, type Y Enter, and then displays the key): Direct Enter
Also shows rear [Y / N]: Enter Y input line
After about twelve minutes the like you will find only the power lamp AP cable connection On