Weak current box + only one network cable in the living room, and at the same time IPTV + AP router function, no VLAN switch is needed (using the remaining network ports of the optical modem)

Purpose of this article:

Record the pitfalls you have stepped on

No needvlan交换机, achieve soft routing + IPTV + AP wireless router. ,

I have seen many solutions on the Internet that require buying two VLAN switches for single-line multiplexing.

In fact, the single-line multiplexing here is optical modem and AP wireless router.

I went back and forth on this thing for a long time and spent 3 days on it. Finally, I got this result.

I bought a VLAN switch, but I can't use it now.

Directly look at the final topology map

equipment

1. Optical modem: China Unicom 4LAN Gigabit port
2. Honor router XD21: supports iptv dedicated port

Ideas

Optical modeLAN1 Link soft router ikuai**ETH0-WAN port PPPOE dialing

Soft router ikuaiETH3 - backhaul line - transmit network data to optical modemLAN3port

Optical ModeLAN2 is connected to the WAN port of "Honor XD21 Wireless Router", and the LAN2 port of the AP Router is connected to Wo TV Box (PPPOE) TV dial-up.

Optical modemLAN4 Connect to other rooms. If you need more, add switches...

Configuration

study

Equipped with 2 network cables to weak current box, soft router, NAS, computer

Weak current box

Light modem, every room has network cables

living room

1 network cable to the weak current box, but both IPTV and AP wireless routing are required.

The following are various topology methods, all of which have been implemented.

The initial network topology diagram:

In this way, there are a bunch of devices in the living room, including switches, soft routers, AP wireless routers, and NAS (the 2.5G port cannot be wasted). The most important thing is that I can't connect the network cable in the study room, which is very annoying.

Then I improved it and put软路由 NAS in the study room, and put a 5-port VLAN in the weak current box. This method is possible, but the weak current box is too small to fit in. Hey, tossing...

Optical cat configuration:

1. This is the network entrance. I configured VLAN ID 20 for ikuai dialing later.

2. This is IPTV dial-up, VLAN ID 30, and the port binding part is all unchecked.

Binding settings

This is very interesting. In theory, it only needs 20/20 30/30, but I don’t know why it doesn’t work... You must configure 20/30

AP wireless router configuration

I use AP mode here, so that it is configured uniformly by soft routing.

The key to IPTV is here. . .

Soft route ikuai configuration

I have configured vlan_id 20 and 30 here to use the m3u on-demand source to facilitate watching sports live broadcasts on the computer.