Cisco and Huawei switch command link aggregation Comparative

Cisco and Huawei switch command link aggregation contrast
project I experienced, there Cisco switches and switch Huawei docking polymerization tied by link two or more physical lines become a logic circuit. Because two brands of switches, wherein the different configurations, cause a slight mistake polymerization unsuccessful line barrier, two brands commands listed below contrast.
(A) Configuration Commands Cisco switches
Cisco switch port is Port-channel logic

1. All the physical port configuration is as follows, note that the logical port which is arranged to automatically follow, which are to be arranged on the physical interface, particularly those confusing.
   By viewing port configuration command, the last physical port configuration as follows:
   interface GigabitEthernet /. 17
   switchport Trunk encapsulation dot1q (following the logic port configuration, without the physical port configuration)
   switchport MODE Trunk (following the logic port configuration, without the physical port configuration)
   Channel-Protocol LACP (link aggregation protocol LACP, the physical port required configuration)
   Channel-Group. 3 mODE Active (active mode, the physical port to be configured)
   is important to note that, when the need to change the configuration, the physical port configuration is not synchronized to the logical port, Conversely can.

2. Configuration logic port
   interface Port-CHANnel1
   switchport Access VLAN 109 (when the logic cancel trunk port, port belongs to VLAN)
   switchport trunk encapsulation dot1q
   switchport trunk MODE

3. Most would link aggregation logical port as a Trunk port, to let through a plurality vlan. Vlan needs to be disabled through the Trunk port configuration commands are as follows, including the following commands is not allowed by vlan1 this point Huawei switches and different.
   switchport trunk allowed vlan remove vlanID

4. When not know which vlan have not been allowed to pass through Trunk port, the view through the following command
   show int trunk module 1

(Ii) Huawei switch configuration, switch configuration and Cisco note the differences.
Huawei switches logical port is Eth-trunk

1. Just as physical port configuration, physical interface view by the configuration commands and synchronization logic port is not configured, and this is different from Cisco.
   the GigabitEthernet0 interface / 0/47
   Eth-Trunk. 1

2. Configuration logic port
   interface Trunk1 the Eth-
   Port-type Link Trunk
   Port VLAN Trunk the allow All-Pass
   MODE lacp (Huawei aggregation protocol lacp port is disposed in a logical port, Cisco is disposed in a physical port)

3. Prohibit certain Vlan through the Trunk port configuration command as follows:
   Use the undo Port Trunk Pass VLanID the allow-
   as Huawei switches vlan1 default PVID, PVID default is allowed to pass through Trunk port. When you want to prohibit vlan1 through Trunk port, you need to change the PVID for other vlanID. Configuration commands follows logically port:
   interface Trunk1 the Eth-
   Port PVID VLAN Trunk 201

4. When not know which vlan have not been allowed to pass through Trunk port, the view through the following command to
   display port vlan

Finally, while Cisco and Huawei switches on different link aggregation configuration commands, but the principle is the same, to be familiar with the configuration of the two brands, in addition to in-depth understanding of principles outside, usually have to practice more and do summarized .