1. Background introduction:
In work and life, it is inevitable to have to transfer large files of more than ten gigabytes between two computers, or to move files to a new computer when changing computers. Other methods are very slow, and the mobile hard disk is not always with you. ,How to do it? The network cables around us can help you, follow me to see how to operate!
This method works from any computer, desktop to desktop, desktop to laptop, laptop to laptop. Specific steps are as follows:
2. Preparation work:
1. Prepare a network cable to connect the two computers.
2. Turn off the computer firewall: This is a very important step. I did not turn it off at the beginning, and then the PING test showed that the request timed out. After checking the information, I found that the firewall was not turned off. Click on the taskbar firewall, or open the control panel and select System and Security, then click Windows Defender Firewall and turn it off.
4. Set IP:
Right-click on the network icon in the lower right corner of the desktop and select "Network and Sharing Center"
Or press the shortcut key "WIN+I" to open Windows Settings, click Network and Internet, and enter the Network and Sharing Center.
Click to display Ethernet ( it may also be called local area connection in win7 ). At this moment, Ethernet is not connected.
Click Properties to enter network settings
Select Internet Protocol version 4, select Properties
Perform IP settings as shown in the figure below
Computer A looks like this:
When setting up computer B, change the IP address. It should not be the same as the first one. The setting range must be 2-254. The default gateway must be the same as the first one. The reason is that the last digit of this masked network segment is The IP with 0 is the network address of the network segment, and the last IP with 255 is the broadcast address of the network segment, which cannot be assigned to a host or selected. . As shown below:
Sometimes you need to turn on sharing on your computer. The steps are as follows:
3. Access method: Enter address + enter username and password (first time)
1. Win+r to open run, enter \\192.168.0.1
2. Enter \\192.168.0.1 in the address bar of the resource manager
3. Enter the account password:
