List of instruments and equipment and main components and equipment for the 2023 National College Student Electronic Design Competition
Undergraduate group
1. Instrument and equipment list
- DC regulated power supply (with constant current/constant voltage mode automatic switching function,
0~30V/3Adual circuit) - Digital oscilloscope (
100MHz, dual channel) - Function generator (
50 MHz, dual channel) - RF signal source (500MHz, -100dBm~0dBm, with RF output switching function)
- Vector Network Analyzer (1GHz)
- Spectrum Analyzer (1GHz)
- Frequency meter (500MHz)
- Power analyzer
- LCR tester
- High frequency Q meter (not less than 20MHz)
- Microcontroller development system
- FPGA development system
- DSP development system
- Embedded development system
- Stopwatch
- 5 meter tape measure
- 1 meter ruler
2. List of main components and equipment
- Quadcopter (maximum wheelbase not exceeding 450mm)
- Electric car (dimensions: length ≤ 35cm, width ≤ 25cm)
- 2D electric pan/tilt
- Camera (can be equipped with processor module)
- Programmable logic device and its download board
- Embedded development system board
- TI MCU system board (can include onboard debugging download module)
- Microprocessor minimum system board (can include onboard debugging download module
- DDS chip or module
- Wireless transmitting and receiving module
- Red laser pointer, green laser pointer
- A/D, D/A converter
- Operational amplifiers, voltage comparators, multipliers
- Variable Gain Integrated Broadband Amplifier
- high power devices
- Sliding wire rheostat (20Ω/6A)
- Single-phase transformer (200VA, 220V/24V)
- Small motors and drivers
- High frequency magnetic ring/core
- High frequency inductor
- LCD
- segment digital tube
- small relay
- varactor diode
- led
- NdFeB magnet disc (diameter 12mm, thickness 2mm)
- Photoelectric Sensors
- Angle sensor
- buzzer
- Piezoelectric ceramic buzzer
- speaker
- Square acrylic flat plate (side length is 450mm±10mm; thickness is uniform and 8mm±1mm)
Vocational and Technical College
1. Instrument and equipment list
- Digital oscilloscope (60MHz, dual channel)
- Function generator (10 MHz)
- Microcontroller development system
- FPGA development system
- Embedded development system
- Stopwatch
- 5 meter tape measure
2. List of main components and equipment
- DC motor and drive circuit
- High speed axial flow fan
- Camera (can be equipped with processor module)
- Microprocessor minimum system board (can include onboard debugging download module)
- Communication module (433MHz)
- Voice module
- High power switch tube
- high power diode
- Operational amplifier, voltage comparator
- small relay
- microphone
- speaker
- buzzer
- led
- 7-segment display digital tube
- LCD
- Ultrasonic probe
- Reflective photoelectric sensor
- Laser ranging sensor
