Create a new thesis three-line table template, one-click format brush

write on top

The thesis is finished, ready to adjust the format
. The previous modeling is also a three-line table, but it can only be based on this document template, so reset it.
as the picture shows:

①Table design, create a new table style

Click the table, [Table Design] appears in the menu bar, select [Table Design];

Under the table on the far right, select the drop-down menu – [Create Table Style];

②Three-line meter on and off the line

Change the table attribute name to [three-line table];

Click [Format] - [Border and Shading] in the lower left corner;

【Custom】Set 【Preview】select the top border and bottom border, leave everything else unchecked, and set the width to 1.5 points;

The state of the form is shown in the figure below:

③Three-line table title line

[Apply the table to] is changed to [Title column];

According to the method just now, click [Format] - [Border and Shading] - [Custom] - select 1.5 points for the upper border, and 0.75 points for the lower border;

Finally, switch [Only this document] to [New document based on this template];

The state of the form is shown in the figure below:

Finally, you can draw a table arbitrarily, select the new style you just created, and apply it!

You can also open a new document arbitrarily, insert a table, and then select the three-line table in [Table Tools]-[Design], and click to change the three-line table in seconds.

After saving the style, you don’t need to rebuild it every time you encounter a three-line form~

④Set the form to the center

Click [Format] - [Form Properties] - [Center]

⑤Set header format

Click [Start] - [Style] - [Create Style]

Setting Name: Table Header
Style Reference: Caption
Format: Boldface, 5th, Centered

error prone steps

The position of creating a table style: After drawing a table arbitrarily, the last option in the drop-down button on the left side of the "Table Tool" - "Design" - "Shading" tool;

First set the line width, and then select the upper and lower positions corresponding to the line width. When modifying the 0.75 line, you must first change "Apply Format" to "Title Bar" in the window;