命令2.netsh wlan set hostednetwork mode=allow
Command 3. netsh wlan start hostednetwork
- Run the command line as administrator;
2. Enter the netsh wlan show drivers command to view the interface properties of the network card (mainly see the wireless network card), the red circle mark must be displayed as "supported network bearer: yes".
2.1 If viewing supported bearer networks: No . Then enter the control panel to replace the wireless network card driver.
2.2 Select your wireless network card, right-click -> update driver;
2.3 Select one of the following to browse my computer for driver software;
2.4 Select Pick from my computer;
2.5 Select the driver that supports the bearer function (if you don't know one by one);
To install the wireless driver in this step, it is not necessary to choose the latest one, as long as it supports the bearer function; then how do you know that the bearer is supported? Please see command 2 in step 2: netsh wlan show drivers
If it still shows no, reselect the driver in step 2.4;
3. After support is Yes, enable bearer.
Run and continue to enter command 2 in the command line: netsh wlan set hostednetwork mode=allow , set the hosted network mode to allow;
4. Enter command 3: netsh wlan start hostednetwork
5. If it prompts "The state of the group or resource is not the correct state to perform the requested operation." or if the WiFi cannot be connected and the WiFi cannot be used, proceed to the following steps in 5.1, otherwise, restart Xiaorui WiFi directly.
5.1 Go to Network Sharing Center and open Ethernet/Local Area Connection Properties
5.2 Turn on the WiFi function,
4.3 Turn on Ethernet/Local Area Connection Sharing and choose to share the network to your WiFi (I don't know which WiFi is yours, open it on the left to change the adapter settings to view)
5.4 At this point, you should be able to create a personal WiFi hotspot, but it may not be connected;
6. Click OK to restart Xiaorui WiFi/WiFi