Windows7 and deepin dual system installation
A long time ago I wanted to experience the
deepin
system
Linux
's release, there is good support for the Chinese, the interface is pretty special.
Here is a list of the pits encountered when installing this system from Windows.
Limited choice to install system from U disk
First use deepin's official installation media software to make deepin's installation boot U disk, and then use this U disk to install the system. In this process, one thing that needs special attention is that it must be hung on the three when installing the system. Partitions
- \ Partition recommended 30G memory;
- \ boot partition, 10G memory is recommended;
- \ home partition, 10G memory is recommended.
One of the most important points is that all partition formats must be selected ext3, otherwise there will be no boot
Configure boot
Here boot is the use EasyBCDof this tool boot, operation is very simple, just add one Linuxto GRUB2start to drive can choose to automatically load the specific configuration as shown below:
After completing the above operations, restart the computer, some photos are as follows
Added on October 19, 2019
After a few months of use, I will add some content. On the whole, the Deepinsystem is still worthy of recognition. The interface is beautiful. It is very simple and convenient to use. It greatly simplifies the Linuxcomplex geek attributes and transforms it into an ordinary white user installation. system.
But there are still many problems:
- There are too few applications in the application store, and the quality is very poor. Third-party application vendors basically have no need to develop Linux versions, such as Evernote, etc. This is a flaw of the Linux system for ordinary users;
- The system is occasionally stuck, and the boot speed is relatively slow;
- Encountered how many times I dragged the window and scrolled the screen, this may be related to my computer's graphics card;