CISCO SDM 官方配置说明

文章來源於 sina 煙鬼博客  寫於 2009-05-05 21:04

Configuring router to run SDM 
Follow the instructions below to configure a router to run SDM.
Step 1:

Connect to your router using Telnet, SSH or via console.
Enter the global configuration mode using the command:
Router>enable
Router#conf terminal
Router(config)#
Step 2 :

Enable the router's HTTP/HTTPS server, using the following Cisco IOS commands: 

Router(config)# ip http server
Router(config)# ip http secure-server
Router(config)# ip http authentication local
Note:- HTTPS is enabled only for crypto enabled IOS images.

Step 3:

扫描二维码关注公众号，回复： 792927 查看本文章

Create a user with privilege level 15.

Router(config)# username <username> privilege 15 password 0<password>（尽量不要用0）

Router(config)# username admin  privilege 15 secret chenpeng

Note:- Replace <username> and <password> with the username and password that you want to configure.

Step 4:

Configure SSH and Telnet for local login and privilege level 15:

Router(config)# line vty 0 4
Router(config-line)# privilege level 15
Router(config-line)# login local
Router(config-line)# transport input telnet
Router(config-line)# transport input telnet ssh
Router(config-line)# exit

Step 5: (Optional) Enable local logging to support the log monitoring function: 

Router(config)# logging buffered 51200 warning