版权声明：[email protected]版权所有 https://blog.csdn.net/weixin_43458720/article/details/89556272
拓扑图
PC和Switch已经配好
在R1配置命令
R1>enable
R1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
R1(config)#
R1(config)#ip route 10.1.1.0 255.255.255.252 209.165.200.224
R1(config)#ip route 10.1.2.0 255.255.255.252 209.165.200.224
R1(config)#do show ip route
Codes: L - local, C - connected, S - static, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
* - candidate default, U - per-user static route, o - ODR
P - periodic downloaded static route
Gateway of last resort is not set
10.0.0.0/24 is subnetted, 2 subnets
S 10.1.1.0/24 [1/0] via 209.165.200.224
S 10.1.2.0/24 [1/0] via 209.165.200.224
192.168.10.0/24 is variably subnetted, 2 subnets, 2 masks
C 192.168.10.0/24 is directly connected, GigabitEthernet0/0
L 192.168.10.1/32 is directly connected, GigabitEthernet0/0
192.168.11.0/24 is variably subnetted, 2 subnets, 2 masks
C 192.168.11.0/24 is directly connected, GigabitEthernet0/1
L 192.168.11.1/32 is directly connected, GigabitEthernet0/1
209.165.200.0/24 is variably subnetted, 2 subnets, 2 masks
C 209.165.200.224/30 is directly connected, Serial0/0/0
L 209.165.200.225/32 is directly connected, Serial0/0/0
R1(config)#exit
R1#
%SYS-5-CONFIG_I: Configured from console by console
wr
Building configuration...
[OK]
R1#
在R2上配置
R2>enable
R2#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
R2(config)#
R2(config)#ip route 192.168.10.0 255.255.255.252 209.165.200.225
R2(config)#ip route 192.168.11.0 255.255.255.252 209.165.200.225
R1(config)#exit
R2#
%SYS-5-CONFIG_I: Configured from console by console
wr
Building configuration...
[OK]
R2#