上次修改redis配置后 没有重启过 今天直接使用 redis-server 启动抛错
Redis Client Error ReplyError: DENIED Redis is running in protected mode because protected mode is enabled, no bind address was specified, no authentication password is requested to clients. In this mode connections are only accepted from the loopback interface. If you want to connect from external computers to Redis you may adopt one of the following solutions: 1) Just disable protected mode sending the command 'CONFIG SET protected-mode no' from the loopback interface by connecting to Redis from the same host the server
is running, however MAKE SURE Redis is not publicly accessible from internet if you do so. Use CONFIG REWRITE to make this change permanent. 2) Alternatively you can just disable the protected mode by editing the Redis configuration file, and setting the protected mode option to 'no', and then restarting the server. 3) If you started the server manually just for testing, restart it with the '--protected-mode no' option. 4) Setup a bind
address or an authentication password. NOTE: You only need to do one of the above things in order for the server to start accepting connections from the outside.
这里注意redis设置密码后 启动命令记得加上密码
如：密码为 000000
启动命令为：
redis-server --requirepass 000000修改后就可以正常连接啦