Keil Debug (printf) Viewer

Keil Debug (printf) Viewer

Debug (printf) Viewer

Home » µVision Windows » Debug (printf) Viewer

The Debug (printf) Viewer window displays data streams that are transmitted sequentially through the ITM Stimulus Port 0. Enable ITM Stimulus Port 0.

To use the Debug (printf) Viewer for tracing:

1. Add ITM Port register definitions to your source code.

   #define ITM_Port8(n)    (*((volatile unsigned char *)(0xE0000000+4*n)))
   #define ITM_Port16(n)   (*((volatile unsigned short*)(0xE0000000+4*n)))
   #define ITM_Port32(n)   (*((volatile unsigned long *)(0xE0000000+4*n)))
   
   #define DEMCR           (*((volatile unsigned long *)(0xE000EDFC)))
   #define TRCENA          0x01000000
   

2. Add an fputc function to your source code that writes to the ITM Port 0 register. The fputc function enables printf to output messages.

   struct __FILE { int handle; /* Add whatever you need here */ };
   FILE __stdout;
   FILE __stdin;
   
   int fputc(int ch, FILE *f) {
     if (DEMCR & TRCENA) {
       while (ITM_Port32(0) == 0);
       ITM_Port8(0) = ch;
     }
     return(ch);
   }
   

3. Add your debugging trace messages to your source code using printf.

   printf("AD value = 0x%04X\r\n", AD_value);
   

4. Set the ITM Port 0 to capture the information. Clear the Port 7..0 privilege bit to access ITM Port 0 from User mode.

   

5. Open the View - Serial Windows - Debug (printf) Viewer window.

 Note

• ITM Stimulus Ports can be monitored in the Instruction Trace Window, where ITM Port 0 is shown as well.
• Consult Configure Cortex-M Target of the MDK-Primer for information on how to retarget the output.

http://www.keil.com/support/man/docs/jlink/jlink_trace_itm_viewer.htm

https://www.douban.com/note/248637026/