About XC7Z010 development board
Details http://www.myir-tech.com/product/myc_C7Z010_20.htm
Xilinx 28nm process based on the Zynq-7000 All Programmable SoC platform is a single-chip solution for ARM processor and FPGA combination, both very suitable for applications requiring an FPGA and processor, after so many years of development, the application has been on the market very much, it is a very popular embedded development platform, Mill XC7Z010 development board (http://www.myir-tech.com/product/myc_C7Z010_20.htm) Technology Co., Ltd. Shenzhen Mir earlier launched a high-performance high quality ZYNQ development board, thanks to the technology trial activities and Kashmir breadboard community jointly organized, I had the honor to try to get a chance to feel close to and experience this popular embedded development platform, we first of hardware development boards to be understood that the situation may be more straight peripheral view with a picture.
About XC7Z010 development board Note:
1, SFP, PCIEx2, SATA and other peripherals need to take when ZYNQ-7015 core board can be used.
2,3 PMOD only when the interface bonding ZYNQ-7020 core board can be used, ZYNQ-7010 can not be used.
3, there is no on-board development board downloader, leaving the upper right portion of the 2X7 pin JTAG interface, note the pitch of 2.54, it is the first leg of the triangle is connected, you can see MYC_C7Z01020 introductory instruction manual .pdf page 40, as follows icon:
XC7Z010
Two triangular red circle is denoted as a first pin, pin line association, taking into account that some may not be very downloader cable specification, preferably by measuring a ground pin is shorted way to determine JTAG direction of more reliable, JTAG signal connection FIG XC7Z010 development board as shown below:
4, Jumper For CAN, after the connection jumper terminated in a 120 ohm resistor CAN differential signal, as shown in the schematic diagram:
5、BOOT SELECT和JTAG FUNC SELECT，BOOT SELECT对应跳线帽JP2, JTAG FUNC SELECT对应跳线帽JP3,这两个跳线帽的高清照片如下：
这里JP3看板上丝印写的Sel Independed JTAG表示选择ARM和FPGA复用JTAG或独立JTAG（需要PL配置PL端引脚做JTAG），即ARM和FPGA的JTAG接口分开的意思。
6、WDT_EN，这个跳线帽连接后使能硬件看门狗电路，如果软件中没有使用看门狗（定时清除）的话， 需要断开这个跳线帽，否则会导致开发板不断的重新启动不能正常工作。
最后总结下试用的MYD-C7Z010开发板的外设情况：接到ZYNQ PS(ARM)部分的有千兆以太网、 USB(通过底板上的USB HUB芯片USB2514扩展成4路USB Host) 、 CAN、UART、I2C、按键、JTAG、TF、RTC、WDT、4GB EMMC、32MBQSPI、1GBDDR3等； 接到ZYNQ PL(FPGA)部分的有FMC(Xilinx标准LPC接口)接口、XADC、HDMI TX(YCrCb 16bit，不支持音频)、LCD显示和触摸屏TP。至此，对开发板硬件资源有个基本的了解，接下来可以对具体外设进行测试。