Comprehensive OSPF, VLAN, RIP, single-arm routing experiment, the entire network interworking
Introduction: According to what has been learned previously, are now trying to learn the content together, put in a test topology, so that the whole network can communicate. The main thing is to consolidate this knowledge, a deeper impression.
Experimental topology is as follows:
One: Introduction experiment
First need to interface address of each router configuration, from the left sequentially beginning, Rl, SW and the following hosts this part configure static routes, need to be divided vlan10 and vlan20 the SW and SW2, R1, R3, R4 configure ospf protocol, R4, SW3 need to configure the RIP. Here we take a look at the specific steps.
1, SW configuration
First two interfaces divide f1 / 1, f1 / 2 corresponding vlan, f1 / 0 vlan trunk configure
2, R1 is arranged
First configure the interface address, but also need to vlan10, vlan20 division come. Then f0 / 0 area1 divided in this interface, the following two segments also need to be injected into the area1, prior to injection on the network segment, the router needs to configure the address of R1.
3, R3 configuration
First, you need to configure ip address, and then configure the loopback address, and then declare their own interfaces to the area and area1 area0 of their own, and then configure a static route, the next hop address is 13.0.0.2.
4, R4 configuration
First configure the address of each interface in the loopback address configuration, declared in declaration Area0 13.0.0.0 segment, and finally re-routing distributed to ospf injected into the rip, the rip injected into ospf.
5, SW3 configuration
First, an interface address, f1 / 0 Trunk required, the configuration vlan10,20, configure an address corresponding to the vlan on Layer 3 switches, then declare three segments corresponding to the rip
6, SW2 configuration
First configuration vlan10,20, and then configure the interface belongs to which two vlan, f1 / 0 also need trunk
7, the final four hosts ip address configuration, and then ping each other and can ping the description of the whole network interworking.
The entire experiment in the process of doing the idea should be clear, before which one do you want to know what they want to configure, it is about what agreements. Done after each step to see whether they want to verify the configuration is complete.