Foreword
Units recently went to practice, but not with the computer, so have to carrying on my computer after work.
But we found a big problem in the work process. As the perennial use an external monitor, so I did not actually find the internal display quality is so low, there is not only a greasy spot.
This day I am looking at screens eyes uncomfortable, so I decided to change a screen.
Screen for
Original screen is NV156FHM-N41 panels it is spam, 47% of the NTSC color gamut, 30ms latency, higher than the actual 30ms delay, jitter 8-bit. But this is not important.
I changed the new screen is N156HCE-GA2, Amoy from the XY perfect screen.
Screen notebook back panel are basically the same. Gold lower right corner of the screen interface is 30pin line.
Then begin to disassemble. Remember the first battery removed.
Then find this place bottom of the screen.
The black sticker tear
Remove the screws to the front and rear plates of the screen is connected by a snap, direct hard-to pry open the line.
Note Do not force the plastic snap-snapping.
Four corners of the screen by means of screws fixed as long as the discharge screw 4 on the line.
Screen line glued to the panel, so do not be too hard.
Here to tell a little trick: After changing the screen Do not cover the B-side, switched on the screen to the brightest, black display, turned off the light. Take a look at where there is light leakage. Then adjust the screw tightness. Until then covered with a little light leakage.
Boot automatically become 120, and do not need to transfer.
to sum up
Writing this blog is mainly for the screen laptop really is not hard to say, do not need to have a strong practical ability. Be careful on no problem.
Now laptop screen refresh rate is high not expensive, and the old screen can also set a portable screen.
But there are a few considerations:
1. The selection screen of their computer time to determine what format screen line, find the corresponding screen. As I have here is the eDP 30pin. If you want to change eDP 40pin screen would need to replace the screen line.
2. Be sure to gently, after all, the screen is relatively weak.