How to use the switch to make two PC end interoperability in GNS3
Summary:
GNS3 is a with a graphical interface can run multiple platforms (including Windows, Linux, and MacOS, etc.) network virtualization software. Cisco network device administrator or want can be done by the relevant experiments to simulate the actions stakeholders CCNA, CCNP, CCIE and other Cisco certification exam through it. It also can be used for virtual experience Cisco IOS IOS or test to be deployed configuration implemented on a real router.
Actual operation:
- Experiment 1: VPC connection using GNS3 comes complete switch interoperability
add a router
to configure the router
to add a switch unit
renamed to switch
to change the icon for the switch icon
to add two VPC
connection VPC and switch
turned on all devices
, double-click to open the switch CRT program
into the global mode, turn off the routing function
, double-click to open each PC1, PC2 of the CRT program
to configure the IP address and subnet mask PC1
to PC2 configure the IP address and subnet mask
with two PC PC1 verify whether interoperability, interworking success - Experiment two: VMware connection with the use GNS3 in the switch, and to achieve interoperability
closed switch and remove other devices
to open two virtual machines, and enter the virtual network editor to
change the configuration
adds a card
to cancel local DHCP server to assign IP addresses to virtual machines
the virtual machine win10 VMnet1 card is set to
the virtual machine win10-1 VMnet2 card is set to
add two Host
to Host two were used VMnet1 VMnet2 connected to the switch and
to check the correct interface
are two virtual machine to configure an IP address
to close both virtual firewall
turn on the device
is turned on Wireshark capture carried
into the win10 virtual machine command prompt
enter ping 192.168.8.10 -t test whether two virtual machine interoperability. Successful interoperability test results, capture succeed.