Playing with ansys - solid modeling and simulation of cantilever beam quality block

---

foreword

The software version used in the experiment: ansys10.0

---

1. Experiment description

(1) Experimental model diagram

(2) Problem description

The force model of the cantilever beam is shown in the figure above, a beam with a length of 100 [mm] is fixed at one end, and the other is subjected to a concentrated force F parallel to the beam section, F=100 [N]. The cross-section of the beam is a square with a side length of 10 [mm]. Materials used for beams: modulus of elasticity E=2.0105[MPa], Poisson's ratio 0.3.

---

2. Calculation steps

以梁单元为主介绍。

(1) Analyzing the problem

Analyzing the physical model, it can be known that section side length/beam length=0.1 is a