Esxi 6.7 installation tutorial
The following software is required
Floppy Disk: http://cn.ezbsystems.com/ultraiso/
Esxi 6.7 iso file download address
Link: https://pan.baidu.com/s/1e0f9vfdQ25yJE_h_gEUGiQ Extraction code: hbum
Step 1: Make a bootable U disk.
Prepare an 8G blank USB flash drive, the system will format your USB flash drive.
Start the UltraISO software, just click here to continue the trial.
After opening, select in the upper left corner of the software: File-Open, 
select the system image you need to write, and then click Open
After opening, insert the USB disk, select the opened file and click Start to write the hard disk mapping, as shown in the figure:
Select the U disk to be written and click Write, wait for the reading to complete, and the U disk installation system will be created.
Step 2: System installation
Insert the bootable U disk before the server is started, and press F12 to enter the system installation interface after startup ( each startup button is different, I will use an ordinary computer for demonstration here )
The following screens appear sequentially and can be skipped directly.
Press Enter directly to continue. 
Press F11 to accept the terms. 
Select Esxi 6.7 to install the hard disk. After selecting
, press Enter to set the default
layout of the keyboard. characters and the length is greater than 6] ) 
Press F11 to start installing Esxi 6.7
After the progress bar runs, the installation is complete! Press Enter to restart.
After the restart, the following screen appears, indicating that the installation is successful. The installation of the entire Esxi system is over. The next step
is to configure the IP address, and press F2 to enter the account password [the password was set during the previous installation]
After entering the password, enter the system Customize the interface, select the configuration management network [as shown in the figure]
After entering the network configuration interface, select IPV4 configuration [as shown in the figure] to select the last one, press the space to select, and then enter [IP address] [mask] [gateway]
in the following three areas and press Enter directly after completion, It will return to the previous interface and then press ESC to exit the network configuration. It will prompt you that the network has been modified. Applying the changes will restart the network configuration. Press Y to apply the configuration. Finally, press ESC to return to the main interface. Use another computer to open the browser server, enter the IP you just configured, and enter the virtual machine login interface.
At this point, the installation is over