Original_Xinmobaihe CM201-1 regardless of OEM Hongmeng architecture when Bellejia voice Android 9 line brush firmware package brush machine tutorial can save brick rom flash machine package
(The flashing package and tutorial will be mentioned at the bottom of this article)
The author carefully developed a ROM firmware after many times of improvement and reorganization. The characteristics of the ROM firmware are as follows;
1. Transplant the Hongmeng architecture code, perfectly integrate the Android system, and increase the stability of the system;
2. The system automatically recognizes the machine configuration;
3. Android public version system production plus TV box firmware integration;
4. Increase the Sony imaging engine;
5.CPU and GPU algorithm changes, when watching 4K film sources, AI intelligence will automatically optimize the background process of the system,
Close redundant processes and automatically enable GPU full-load acceleration; make the screen smoother;
6. When the hardware temperature of the box reaches a preset degree, the background will automatically optimize the GPU operation to quickly cool down and prolong the life of the hardware;
7. The adb function is supported, the system adds a boot-up self-start function, and adds an elderly desktop mode, which defaults to a younger desktop; one-click selection
Elderly mode; one-click to open a TV application; more user-friendly;
As I said, this firmware is made using the Android public version image, so the foundry also uses the public version image,
So the firmware I sent can be applied to the box produced by _cw_ys_zg_zn OEM;
The difference between those dedicated foundry firmwares is that this public version of the image system has a higher level of scalability and greater scalability; the general S905L
S905L2 and S905L3 are perfectly compatible with or without wifi hardware boxes; the system's built-in AI intelligent recognition can be used as long as it can be swiped into it!
Don't worry about bricking, because the system kernel will automatically judge the partition and CPU level, assuming your CPU is higher than S905L3 then
When flashing, he will automatically short the link, so there is no bricking.
***********************************************************************************************************
Netcom flash firmware package: { Click here to download }____{ alternate download link } Click the text in brackets to download;
After downloading the firmware, decompress it, then download and install the flashing tool to the computer, run the flashing tool to load the img firmware in the attachment
At this time, insert the power cord into the box (don’t open the power button), use tweezers to clamp the 4R12 resistor on the back of the motherboard and don’t let go, then insert the data cable
Finally, turn on the power button of the box, when the flashing platform shows that it is connected, you can release the short-circuit point, and click the start button to start programming;
Please refer to the figure below for the precautions;
Except for the 4R12 resistance logo on the back of the main board of the CW foundry box, all other foundries are marked, and the back of the main board
100% can be found, the following is mainly to point out the shorting position of CW OEM because he has no text
The CW foundry is at the lower left corner of the motherboard;
Flashing is risky, you need to be careful when you do it, the website and the author will not be responsible for any problems caused by flashing