【Getting Started】Basic configuration of eNSP static routing
brief description
Static route:
Static routing is a routing method in which routing items are manually configured rather than dynamically determined. Unlike dynamic routing, static routing is fixed and does not change even if network conditions change or are reconfigured. Generally speaking, static routes are added to the routing table item by item by the network administrator.
·Manually configured by the administrator, is one-way
· Lack of flexibility
experiment
It is required that PC1 and PC2 communicate with each other.
1. Configure PC1 and PC2
After the configuration is complete, you can check whether the configuration is complete on the command line
2. Configure router port IP
It is recommended to change the name of the router, and close the prompt information, the same operation for the three routers
First configure AR1
AR2
AR3
3. Configure static routing
It can be seen that AR1 needs to configure two paths, and AR2 and AR3 need to configure one path each.
AR1
The former IP is the destination network segment, and the latter IP is the next hop address
AR2
AR3
Above, the configuration of the static reason is completed, and finally check whether it can be pinged
Both PC1 and PC2 need to try whether they can be pinged