Although WIN7 has been out of service for half a year, the 10th generation CPU and B460 motherboard have been on the market for a while, but some users still need the WIN7 system, so today it is necessary to talk about how to use the B460 motherboard + Intel 10th generation CPU i5 10400 +H630 core display installed WIN7 system. If you install WIN7 according to the previous system installation method, you will always be stuck in the login LOGO interface and cannot enter the deployment interface, regardless of the packaged system image or the original system image. It is necessary to inject the USB3.1 driver and H630 core display driver into the target system in advance in the PE environment to enter the deployment interface normally. The injection tool I choose the driver of the system president 2.0 early adopter version, mainly because there are USB drivers and H630 drivers required to support the Intel 10th generation CPU to install WIN7, the injection timing is to inject USB into the target system in PE immediately after restoring the image. Drivers and Core Display Drivers. Next, I will demonstrate the actual operation process.
Before starting, do some preparatory work. This tutorial uses Colorful B460 motherboard, Intel i5 10400CPU, ordinary SATA solid state drive, no independent graphics card, and the U disk used for reinstalling the system is a 512Pro solid state U disk customized by IT Sky. The PE system uses the latest version of IT Sky Youqitong 3.5, and the U disk is made into a PE boot disk in advance, and the image uses the Intel3X0 motherboard + AMD RyzenCPU general WIN7 64-bit image of this site. Download the image in advance and put it on the U disk. Root directory.
Now newly configured computers generally have CSM compatibility mode turned off and secure boot turned on by default. Therefore, when installing WIN7 in a new configuration, you must turn off the secure boot in the bios and turn on the CSM compatibility mode to install the WIN7 system normally. We need to change the settings in the bios. Plug in the U disk before booting, and press the Delete key quickly to enter the bios interface while booting. The setting interface of various motherboards may be different, but these letters are the same and remain the same. Here is the BIOS interface of the colorful motherboard. First close the secure boot as shown in the figure below.
Turn on CSM, and the startup mode defaults to uefi startup.
After setting, press F10 to save and exit.
Quickly tap F11 while restarting, the shortcut key for selecting the startup device of the Colorful motherboard is F11. Then select the U disk boot disk and enter PE.
After entering PE, we follow the steps below to repartition and format the SSD. Data is very valuable, partitioning needs to be careful! Since we chose uefi as the startup method, we must set the partition table type to GUID and install the system in GPT mode.
After the partition is completed, follow the steps in the figure below to select the WIN7 system image to be installed that was downloaded earlier. Remember not to tick Restart the computer. There are still things to do after the image is restored.
After restoring the image, we then injected the USB driver and the nuclear display driver into the target system in the PE. The injection tool used the driver 2.0 early adopter version downloaded earlier. Note here that the system drive letter needs to be manually confirmed by yourself. The system drive letter is sometimes messy, and the target system drive letter is not necessarily C, so pay attention to this.
Several necessary drivers required by the target system have been identified.
After the injection is completed, you can restart it, and you can unplug the USB drive. ES5-packaged systems are just that wayward.
After restarting, enter the login LOGO interface, here it takes dozens of seconds, and then it can be deployed normally. If the driver is not injected in advance, it will be stuck here and cannot enter the normal deployment interface.
Handsome ES5 deployment interface
Familiar Universal Drive 7
The following picture is the effect after installation and the hardware configuration screenshot of this tutorial.
The tutorial is over, the work is over, and the real hardware configuration is posted.
