Win10 installation & system backup & system restore

 

Experimental case: Use PE toolbox to install Win10 operating system

1. Create a Win10 virtual machine

1. Create a new virtual machine

 

2. Start the installation system

 

Choose a custom installation

It must be formatted here, otherwise the disk may not be opened after installing the system

Click next

Enter account number and password

 

three.

Use U to enter PE:

Click on the red box to edit "Edit virtual machine settings"

Use U to start the virtual and enter PE, first need to add a physical disk.

Click ① "Add", then ② "Hard Disk", then ③ "Next"

Next step

Choose to use a physical disk here, click Next

In the case of multiple hard drives, select "PhysicalDrive2" means U disk, click next

Click Finish

Then click "Done" in the red box

Click the inverted triangle to the right of the green triangle, and then click "Enter the firmware when the power is turned on" to enter the BIOS setup interface

First select ① "Boot", then select "-Hard Drive" and press Enter to open the menu, move ③Mware Vurtual SCSI Hard Drive (0: 1) up with +, and finally press F10 to save and exit and restart.

Enter the menu and select [2] number to enter PE

Four. System backup

or

 

Started backing up

V. System Restore

or

 

 

the above