Step One: Select Install CentOS7 to install
Step two: Select the installation language, it is recommended to select English, then click Continue
The third step: sequentially [software selection] and [partitioning]
3.1, software installation options, recommended to choose the beginning of the GNOME desktop environment GNOME select additional applications, Internet applications, and development tools
Step Four: partition operations, may choose to automatically partition
4.1, manual partitioning
4.2, manually partition configurations, click [I want to configure partitions] Click Finish
4.3, enter the manual configuration partition interface
Click + to add a partition;
Select mount point for swap partition (Windwos corresponding to virtual memory), and to set the capacity 2G
Then click Mount
Click + add a second partition;
Mount point selection / root (corresponding to the C disk Windwos), and set a capacity of 18G
Then click Mount
After adding mount points
Click Finish
Step 5: Start the installation system
Create a regular user to log into the system
Create a root password for advanced operations
Click ROOT password, enter click Finish (ROOT password requires a certain strength of the password it would not pass)
Create a login user ( user used to log system used )
After completing the installation continues to wait
After rebooting licenses and network configuration
Click to agree to this agreement
Click Finish
Configure network connections
Network configuration can be selected Dynamic IP or Static IP
I choose here is the static IP
IP address and routing must be above the same network segment
enter the system
Click Install user-created
System installation is complete, you can then use the official