Hello everyone I'm your friend JamesBin, the lesson we have learned to add a new device, this lesson we'll look at how to verify with their add devices if they're right.
Bo Software verification and add the correct equipment
First, verify that you can carry out simulation program
1, the new variable
Establish three variables in the variable table as shown,Note that the variable type and address
2, programming
If not, then something ⑧ referred to above can be found on the right side of the conventional.
There are two ways to join the modules, which are drag and click, drag directly drag the past, click on the need to click on the position where you want to put in, then click on the block want to join.
3, download
Click on the top of the download button, the download button shown in FIG:
Click as follows after the pop-up window;
after scanning as shown for download;
click to start all:
Wait for the download to complete.
Monitor screen
Open the Watch button (if it is gray explanation is not running, you need to click on the run and then run the program monitor)
So far our programs and projects are no problem, the basics of programming we want to start the next. We can focus on my study industrial together.
