DSP emulation debugging steps
1. simulation debugging steps
Emulator connected by USB cable to the host, operation is as follows:
- To ensure that all equipment is powered off.
- Installation JTAG emulator cable, and connect to the target board JTAG connector.
- Connect the emulator to the host via a USB cable.
- Power-emulator.
- Target board is powered on.
2. Considerations
- Or the case where the target plate emulator charged, non-removable JTAG interface emulator.
- USB cable Do not use the front USB interface to connect a desktop computer.
- Proper power-up sequence is:
A) all-off device
b) JTAG emulator connected to the target board street
c) connecting a USB cable or a network cable
d) on the emulator electrically
e) electrically target board
Off in the reverse order to the above process.