- Name: Cai Jinyu
- Student ID: 201821121070
- Class: calculated 1813
table of Contents
1 Purpose
- Master OSPF configuration
- Build understanding and OSPF routing table updates
2 Experimental content
Use Packet Tracer, properly configure network parameters, use the command to view and analyze OSPF routing information.
- Establish a network topology
- Configuration parameters
- Analysis of OSPF routing information
3. The test report
3.1 Establish a network topology
Network topology as shown below:
4. Configure
4.1 Configure and activate Serial and Ethernet Addresses
Note: The router configuration is given only a configuration on the line. PC configuration is given a configuration on the line.
4.1.1 R 1
4.1.2 R2
4.1.3 R3
4.1.4 PC
PC0:
4.2 Configuring OSPF
4.2.1 R 1
4.2.2 R2
4.2.2 R3
5. Verify that the correct parameters
5.1 verify the correct IP address and the interface is active
5.2 Any two machines can successfully Ping
6. Verify OSPF routing
6.1 modify the route ID
This step is to allow follow-up understanding of OSPF routing.
Note: Be sure to save reload
6.2 verify the operation of OSPF
View and OSPF neighboring router information:
Check the OSPF routing 6.3 routing table
View routing protocol associated with the operation of information: