A few days ago to share how the VMware installation CentOS system, then there is a small consulting partner in the group, when the new virtual machine, open the virtual machine pop "out of physical memory to the setting set to open virtual machine" problem ,As shown below. Here will be given tips will allow you to reduce the memory size to 20352MB .
The reason is because when some small partner in the initial installation of the virtual machine system, because they do not know how to configure the virtual machine, so as much as possible to the virtual machine configuration higher, if blindly increasing the height configuration, can cause physical phenomena produce low memory, we solve this problem, give a solution.
1 , to ensure that the virtual machine is shut down state, as shown in FIG.
2 , then click on the "Edit virtual machine settings", as shown in FIG.
3 , and later pop-up interface in the figure below, this is the time before creating the virtual machine to the specified memory size ( 20GB ).
4 , now only need to read the memory size of the error prompt 20352MB can, as shown in FIG.
5 , and later re-opening operation of the virtual machine, as shown below.
6 , the thought that this problem can be solved, but very unfortunately, overturned again, as shown below.
7 , here again prompt the same error, and memory size again dropped a notch reason that we also need to look at memory compression, the same method to set the same before, not repeat them here. Simply the memory size to 16GB . That 16384MB , as shown below.
8 , after setting, can VMware see the device information home page of the virtual machine, as shown in FIG.
9 , again trying to open a virtual machine, as shown in FIG. The virtual machine can be started up normally.
So far, the "physical memory can not be used to set the configuration of the virtual machine is turned on," the problem has been resolved, and later will be able to install the virtual machine operating system and so on.