First use the hot air of the hair dryer to blow off the foam pad, and then use a Phillips screwdriver to unscrew all the screws under the front foam.
The back is deceptive. don't move.
After that, just remove the screws when you encounter them.
The screws are removed. Just pull out the glasses, and a miracle will happen with great effort. The rest of the structure is clear so it won't be shown.
The only subtlety lies in the ability to adjust the equidistance of myopia. The specific details are as follows:
Turn the knob all the way just enough to allow the bar to hold vertically for easy capping and screwing.
The following is DIY, don't enter the handicapped party! !
Since it only supports the use of 4.7-5.5-inch mobile phones, it is difficult to meet the requirements of most high-end mobile phones at present, so DIY is carried out to meet the current mobile phone requirements
Cost saving version:
①Cut the foam at the screw hole for easy disassembly later.
② Put the two rubber bands on the protruding positions of the screw back cover respectively, and then install the back cover. Use two rubber bands to fix the mobile phone. It is very stable when it does not shake a lot. You can also put a rubber band horizontally to the adjustment knob, and the mobile phone will be more fixed.
③ Cut the protruding and obstructing part so that the mobile phone can be put down.
④ You can choose whether to use the front cover, because the author's mobile phone is too thick to use, so I use the rubber band. cry/(ㄒoㄒ)/~~
Here are the details:
DIY, yyds! ! Ugly is ugly, but it works! ! ! In the later stage, 3D printing will be considered to design a front cover to adapt to the current thickness and length. But it costs money, isn't the rubber band delicious? !