Tongxing T1014 online playback settings and solutions to common problems
1. Connect the hardware with Tongxing T1014 for online data playback
1. Connect the Tongxing T1014 hardware to the computer;
2. Open the TSMaster software and configure the channel in the channel selection option. The hardware supports a maximum of four channels, so I choose four channels here;
3. Inbus hardwareAccording to your own needs, adjust the relevant parameters,CAN controller typeThis time it is modified to CAN (default is ISO CAN FD), and other parameters remain unchanged;
4. IndatabaseAdd the DBC file to the CAN channel, and load the DBC file to the CAN channel:
5. Select online playback in the bus playback
6. Right-click to select the record file
7. The selected file format must be in blf format, otherwise an error will occur. If it is an asc file, it needs to be soft. Convert to blf;
8. Load the converted blf file
9. Physical channel mapping,original channelThat is, there are several CAN messages in the blf file you recorded,purposeThe channel is the four physical channels of the Tongxing T1014 hardware, which is the physical channel through which your blf file is sent to the bus; 10. There are two
channels of CAN recorded in my blf file, and I need to map these two channels of CAN to On the physical channel 1 of the T1014, the physical channel 1 will send two channels of CAN data to the bus;
11. When you turn on the playback, you may encounter the following situation. The error in Figure 1 is because you have not connected the physical channel. On the bus or on the bench, there is no CAN bus environment provided, the physical channel is not connected to anything, and the error in Figure 1 will appear when the playback is started directly; the error in Figure 2 shows thatFailed to open log file, generally because the record file asc file is not converted into a blf file, please refer to the content of the seventh part above to explain the file conversion; 12. After the
loading is successful, you can check the status of the message sent to the bus, and you can see the blf file record The two channels of data are successfully mapped to physical channel 1, and physical channel 1 sends the data to the bus;
13. In order to verify whether the physical channel 1 sends data to the bus, use other CAN tools to connect to the bus length to check. The software used is CANTest. At this time, open the TSMaster online playback function. The data seen in CANTest is shown in the figure As shown, our operation is verified. At this time, physical channel 1 does send data to the bus.
2. Online data playback via Tongxing T1014 virtual channel
/**This function is a virtual channel designed by Tongxing officials to facilitate learning, but there is no hardware for drills. It can only be simulated online playback in the software. There is no difference between online playback and real environment playback. The specific operation as follows; /
1. All the channels can be modified into virtual channels, and other operations are the same as those in Title 1, except that there is one link that connects the hardware to the bus, and other operations are the same;
