I believe that with the widespread use of computers, the model, configuration, and system of the computer are also changing and developing. However, no matter how much development, the computer is still relatively prone to some system problems. For example, many friends recently reported that when the computer is turned on. The situation of 0xc000007b appears , what should we do at this time? The editor will tell you below!
Causes and corresponding solutions of 0xc000007b appearing on the computer:
The situations that may cause the 0xc000007b blue screen to appear are as follows:
The first case of blue screen 0xc000007b: virus.
If your computer is infected with a boot sector virus, you may receive the "Stop 0x0000007B" error message. If the problem is intermittent and you can start Windows, check your computer for viruses. If you find a virus, also check the floppy disks for a virus before using them again.
The second case of 0xc000007b blue screen: driver.
You may receive a "Stop 0x0000007B" error message in the following situations:
A device driver required by the computer's boot controller is not configured to start during power-on.
A device driver required by the computer's boot controller is corrupted.
Information in the Windows XP registry (information about how device drivers are loaded during startup) is corrupted.
Windows XP requires a miniport driver to communicate with the hard disk controller used to start the computer. If Windows XP does not supply a device driver for the controller, or is using a corrupt or incompatible driver, you must replace the driver with a valid copy that is compatible with your controller and Windows XP.
The third situation where the 0xc000007b blue screen occurs: the installation is interrupted.
During Windows XP installation, you may also receive a "Stop 0x0000007B" error message if the installer restarts during installation. If you receive a Stop error while the installer is running, you will receive the second error message.
The fourth case of 0xc000007b blue screen: hardware problem.
You may receive a "Stop 0x0000007B" error message if there is a resource conflict between the boot controller and other controllers (or between SCSI devices). You may also receive this Stop error message if the drive conversion has not been performed or has been changed. To resolve this issue, follow these steps:
If there is an IRQ or I/O port address conflict between the boot controller and other controllers, Windows XP either stops responding (hangs) or displays a "Stop 0x0000007B" error message. If new hardware was recently added, remove the new hardware, or reconfigure it so that it does not conflict with the resources of any other previously installed controllers.
If you are using a SCSI hard drive, check that the SCSI chain is properly terminated. Remove any unused SCSI devices, or ensure that each SCSI ID is unique.
Make sure that drive conversion is turned on (if required) and has not been changed. For example, this issue can occur if you have recently replaced your controller.