1. Design theory
The design of wave modeling mainly involves the determination of the wave model, the calculation of various parameters of the wave, etc. This system,
The wave model is as follows:
In reality, there are many types of wave models. This model is used here, mainly because the effect of the model is the closest to the effect on the website you gave.
G is the acceleration due to gravity, taking a constant of 9.8
Two, simulation description
The simulation operation is shown in the figure above,
First click START to start simulating the effect of the waves, and then click stop to pause.
The label in Figure 3 above is the corresponding button on the website to adjust the wind speed.
4 shows the various parameters of the waves. See the theoretical introduction on the previous page for the calculation of specific parameters
5 Here is the display of the 3D effect, you can observe the waves from different angles (the AXIS of the GUI in MATLAB cannot be directly rotated with the mouse for three-dimensional display, so it needs to be displayed through this function)
Through the modeling of the new model this time, and combining the effects of the previous time, the interface of the software obtained this time is as follows:
From the above interface, we can see that there is an extra button for choose power mach in the original interface. The main function of this button is to select different generator buttons.
The following screenshots and explanations of the entire simulation process:
Next, click on the newly put button to select a different generator, and get the following result:
Click again to get the following interface:
The following is an introduction to the side of this new power generation model:
