syslog configuration instructions (only need to be configured in the main UTS)
Two UTS for each node, need to be the main UTS, the one with the smaller IP number
1. In [System]-[Security Management]-[Security Center], configure the "local ip address" and configure it as the M port address , Is to change the original IP of the device, not the mapped 172, but the IP address starting with 10.
2. In "Plug-in enablement item", check the log type plug-in you need to use, click both standard SYSLOG channels, click the [Load Plug-in] button, and then click the [Refresh] button, it will be displayed on the page The plug-in configuration page, as shown in
Figure 1-2 : Figure 1-2
3. Click the [Save] button, it will prompt "Configuration is successful, please in the system configuration -> system control [restart log process]", as shown in Figure 1-3:
Figure 1-3
4. Click the "Restart Log Process" button in [System]-[System Configuration]-[System Control], and click Apply Configuration
5. In the Security Center, you can see that the standard syslog channel plug-in has been loaded, and the standard syslog configuration page appears, as shown in Figure 1-4:
Figure 1-4
6. Enter the syslog server address in the IP column, select the protocol, port, encrypted transmission parameters, and cache parameters, and click the [OK] button. When the connection status displays "Connected", the linkage is successful, and click [Apply Configuration] to take effect, as shown in the figure Shown in 1-5: The target IP address that needs to be configured in
Figure 1-5 
is viewed on the office computer. The destination address in the IP filling form in the above figure is the IP to which syslog will be sent, the protocol is UDP, and the port is filled in according to the form, for example 5154 port. Select No for encrypted transmission and No for cache. Click OK below, and then click Application Configuration in the upper right corner.