Reinstall the system perception of setting the system restore point

table of Contents

Foreword:

Steps to set system restore point:

Foreword:

The editor has been tossing for a long time in the past two days. It is about reinstalling the system. I have some insights. Let me encourage you!

First of all, if you want to reinstall the system, then you must prepare the tools you need: PE system, 360 installer, U disk, etc., then enter the BIOS to set up, then format the C drive for installation, and finally install it. Configure! Xiaobian Nono’s question: Is it cumbersome? ? ?

System installation is a very cumbersome process. Of course, there is also a one-click installation software, but how can you ensure that the installed system matches your local machine? Even if it is installed, a series of operations such as activating the system and installing the driver are required. If there is a problem in any link, your system will be paralyzed for the second time. Today I mainly share how to avoid these:

If you set a system restore point when the system is running normally, then when your system crashes, you can restore with one click:

Steps to set system restore point:

1. Find the control panel and click the system option, as shown in the figure below:

2. Click on the system protection option in the left column to enter, (click on advanced system settings, then click on system protection) as shown below:

3. Select your system disk, and then click the configuration button below, as shown in the figure below:

4. Select Start system protection, set the maximum usage amount (usually 10GB is enough), click OK, as shown in the figure below:

5. Click Create under Configuration, as shown in the figure below:

6. Enter the name of the backup you want to create the restore point. Generally, it is recommended to name it by date and click the Create button, as shown in the figure below:

7. The system starts to create a restore point. The time required varies according to the size of your system, as shown in the following figure:

8. The creation is successful, click the close button to create successfully, as shown in the following figure:

Create a system restore point. When you need to restore the system, enter the system safe mode (forcibly turn on and off the machine more than three times to enter the safe mode, see Baidu for details), click restore!

Set the system restore point, it will be profitable without any harm, let you take action!