The problem of increasing cadence Orcad component numbers

I use version 16.6, please verify other versions yourself.
I encountered a small problem recently, but I got a headache, that is, when copying resistors and capacitors, the device number keeps increasing, obviously there is a lot of space in front. I found a solution on the Internet, and I forgot it after a long time. I couldn't find the URL I referred to at that time. I tried repeatedly recently and finally found a solution. Record it here to avoid forgetting it again.

1. Click option-Preferences
   

2. In the open serial port, select Miscellaneous, find the red line in the figure below in this option, and tick it. When copying resistors and capacitors at this time, it will start with the smallest number.