Designer before the draft design must be delivered to the front-end engineers will use cut map function, but sometimes the resulting cut plan does not meet the requirements of the front, how to do it?
Give us today to share some tips on cut figure. FIG often cut in two forms: the material fills the entire periphery or cutting material with FIG blank area. Take a look at the specific usage of it!
Key Information:
- Cut material to fill the entire map
- Material around with a blank area
- If the figure is below the cut background, how to make the background transparent?
- FIG cut with rapid generation of a blank area in the iDoc (highly recommended)
Material fills the entire cut chart:
- FIG select the need to cut or grouped in layers in Sketch;
- Click Make Exportable the lower right corner, you can upload it to iDoc. ( How do you upload to iDoc? )
- FIG no longer provided more cut rate, iDoc cut automatically generate different magnifications FIG.
The source tape around an empty area:
- Select the need to cut map layers or grouped in Sketch, click Make Exportable lower right corner;
- Then click the "cutter" tool, you can adjust the size of the frame. (Shortcut key is S, press and hold the S drawn directly frame.
If the figure is below the cut background, how to make the background transparent? Program are as follows:
- Sections were cut FIG layers and layers consist need, select the cut FIG layer;
- Check Export group contents only property on the right side panel.
- By the above operation can be guaranteed in the background sections of the case is transparent.
In addition to drawing the outer frame in Sketch in iDoc can also quickly generate a blank area cut with FIG. (highly recommended)
- Click Make Exportable in the lower right corner of the Sketch, the direct upload to iDoc;
- FIG selected cut at iDoc development model, check the "self-sizing" fill mode chosen "center";
- FIG then set the size of the cut need, a key can be downloaded;
- At this time, download is cut with a blank area of FIG. (Note: When setting a size greater than the size of the material itself will appear blank area.)
Today on the tips cut figure will stop here, the little friends go and try it!
