Article Directory
background
Project requirements, put font file into the specified address in the FLASH 32, ST-LINK V2 uses the microcontroller and connected to the computer, and then somehow the font file into the FLASH bin designated by the address with the ST-LINK Utility software. The following record about the whole process:
1. ST-LINK V2 connected with the microcontroller
Bloggers requires only four lines connected to:
- VDD
- GND
- SWCLK
- SWDIO
2. Configure Engineering
Then open the project, configure, select the ST-Link Debugger
and see if the detected ST-Link (select SW)
If you can display the contents as shown, then successfully connected.
3. Configure ST-LINK Utility
After opening the software interface as shown:
Click on the blue ball, open the Settings screen, set the Port to SWD
click on the black plug to connect to the target
4. Burn bin file
Click on the file icon sixth, found Browse the bin file to be burned, burn selected in FLASH start address check by map, and then click Start on it.
Finally mention: ST-LINK Utility can reads ID, FLASH memory chip size at the time of connection.
The need software can whisper bloggers Oh, free
to serve the people
qq: 2723808286
