First, the lab topology
Second, the experimental addressed
Third, the experimental procedure:
1. Configure the PC according to experiments addressing
2. Start the device (Select)
3. Configure router port IP:
R1:
R2:
R3:
4. configuration enables communication between the two branches, headquarters and two branch
PC2 configure static routes on R1, PC1 configure static routes on R3, PC1 and PC2 configure static routes on R1
View R1 routing table:
test:
Can be seen, may communicate, then R1 and R3 and then through PC2
Test headquarters R2 to PC connectivity:
The floating static route configured to implement routing backup
After configuring the routing table:
Note: Use the general view is not the command, use the above command. Using the same configuration at R3
60 100 higher priority than it is to go through R1R3 of default,
Let's close that port test:
TEST PATH:
It can be seen through the path into the R1 R3 R2.
6. Implement network optimization through load balancing
It is to set up two paths for him, not one of too much pressure:
