1. Configuration FIG.
2. Configure command
LSW1 the eth trunk 1 is configured as follows:
Configuration commands are as follows:
[S1] Eth-Trunk1 |
Creating Eth-Trunk1 port |
[S1-Eth-Trunk1]mode lacp-static |
Work mode is set to static mode |
[S1-Eth-Trunk1]interface g0/0/1 |
Into the configuration g0 / 0/1 port |
[S1-GigabitEthernet0/0/1]eth-trunk 1 |
g0 / 0/1 was added eth trunk 1 |
[S1-GigabitEthernet0/0/1]interface g0/0/2 |
Into the configuration g0 / 0/2 port |
[S1-GigabitEthernet0/0/2]eth-trunk 1 |
g0 / 0/2 added eth trunk 1 |
[S1- GigabitEthernet0/0/2]interface g0/0/3 |
Into the configuration g0 / 0/3 ports |
[S1-GigabitEthernet0/0/3]eth-trunk 1 |
g0 / 0/3 was added eth trunk 1 |
[S1]interface Eth-Trunk1 |
Enter port configuration eth trunk1 |
[S1-Eth-Trunk1]max active-linknumber 2 |
Active interfaces on the line threshold 2 |
[S1-Eth-Trunk1]interface g0/0/1 |
Into the configuration g0 / 0/1 port |
[S1-GigabitEthernet0/0/1]lacp priority 100 |
Configuring g0 / 0/1 priority of 100 |
[S1- GigabitEthernet0/0/1]interface g0/0/2 |
Into the configuration g0 / 0/2 port |
[S1-GigabitEthernet0/0/2]lacp priority 100 |
Configuring g0 / 0/2 priority 100 |
View eth trunk configuration is as follows:
LSW2 eth trunk 1 is configured as follows:
Configuration commands are as follows:
[S1] Eth-Trunk1 |
Creating Eth-Trunk1 port |
[S1-Eth-Trunk1]mode lacp-static |
Work mode is set to static mode |
[S1-Eth-Trunk1]interface g0/0/1 |
Into the configuration g0 / 0/1 port |
[S1-GigabitEthernet0/0/1]eth-trunk 1 |
g0 / 0/1 was added eth trunk 1 |
[S1-GigabitEthernet0/0/1]interface g0/0/2 |
Into the configuration g0 / 0/2 port |
[S1-GigabitEthernet0/0/2]eth-trunk 1 |
g0 / 0/2 added eth trunk 1 |
[S1- GigabitEthernet0/0/2]interface g0/0/3 |
Into the configuration g0 / 0/3 ports |
[S1-GigabitEthernet0/0/3]eth-trunk 1 |
g0 / 0/3 was added eth trunk 1 |
View eth trunk configuration is as follows:
3. experimental results
When disconnecting g0 / 0/1 LSW1 port, in which case the backup port g0 / 0/3 will be enabled.