When holding a depression today .. go to the user terminal installation, actually found the instructions can not find it.
'Ve never done recording, on the whole it was very depressing. Go after did not get the feeling quite ashamed of
hard to find from the Internet it is really hard work pays off ah. .
What follows is a summary of several
CDMA module access procedure provided
a) the AT command setting section
(1) AT + CSQ check signal if the digital return signal continues between 10-31,99, 99, 99 if the signal is, you should consider the type A stop / command module to allow non-stop search network.
(2) AT + IPR = 115200 ; & W and save the change rate of the module.
Ii) Set MODEN
(1) Control Panel - "Modem -" General - "select Add - 'not detect Modem -" Standard Modem - "Standard 33600bps Modem -" serial communication port 1
(2) provided 33600 Modem
General - "Serial 1- "highest rate (115200)
c) set the dial network
(1) New connection -" standard 33600 modem
(2) vacant area code - "telephone number: # 777
(3) complete
Four) just double-click the new dial-up network, enter the user name and password CARD CARD, dial-up, testing the user name and password, after landing through the network. Dial-Up Networking logo appears on the lower right corner, you can open IE browse the web.
There are several points to know, where to do a Extracts
1.AT the IPR = 115200 +
2. Standard 33600bps modem
3.115200 highest rate
4. Telephone number: # 777
User: card Password: card
user: password WAP: WAP
Note the test command sets
debugging GMT GMOD2 MODEM, requires port super terminal is connected to the baud rate (bits per second) to 38400.
Dialing instruction
Syntax: ATD <nb> <Enter>
example: calling telephone 96169, in the terminal operates as follows:
Purpose: Let the data MODEM performing a call function, a physical link is established with the other MODEM.
Input: ATD96169
Display: CONNECT 9600
Note: If a call wired MODEM wireless MODEM, wireless MODEM Cable MODEM needs to call the fax number.
4.2 interrogation signal
Syntax: AT + CSQ <Enter>
Purpose: To display the signal strength of the currently received MODEM.
For example: AT + CSQ
show: + CSQ: 31,0
Note: If the + CSQ: 99,99, it indicates that no signal is checked.
4.3 version of the query
syntax: AT + CGMR?
Purpose: To display the current software version of MODEM.
4.4 modify the baud rate
Syntax: AT + IPR = baud
purposes: setting the baud rate. MODEM, and the like may be provided 2400,4800,9600,19200,38400,115200.
For example: AT + IPR = 38400
Response: OK
Answer from 4.5
Syntax: ATS0 = n
Purpose: To set whether the automatic answering MODEM. 0 means no auto-answer.
For example: ATS0 = 1
Response: OK
Meaning: MODEM as the called party, a ringing automatically turned on.
4.6 Save Configuration command
syntax: AT & W
uses: the current settings are saved in FLASH MODEM among the next reboot, the configuration remain