Must-see tutorial - based am335 development board network card directly connected computer card

The PC card and the card development board is directly connected together with the cable, and then start the development board, Run HyperTerminal root, and then execute the command: ifconfig eth0 192.168.254.14, and then execute the command: ifconfig results shown in FIG:

Configured in a development board computer card, as shown:

Click "local connection", as shown:

click "Properties", as shown in FIG:

Next click "Internet Protocol Version 4 (TCP / IPv4)" , then click the "properties", as shown:

select "use the following IP address (S)", and follow the development board NIC configuration to configure the IP address (the I), subnet mask (the U-), default gateway (D), as shown:

Next click "OK."
Attention must turn off the firewall, as shown:

Click "Windows Firewall", as shown:

Click "Turn Windows Firewall", as shown in Figure:

Select "Off Windows Firewall", as shown in Figure :

click "OK", then as shown:

this Windows firewall configuration closed.
Then performs ping 192.168.254.120 (computer local IP) operations in the terminal. As shown in FIG:

Press ctrl + C, exits ping.